Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Electric Gate Repair Across Whitney
Electric gate repair in Whitney usually runs $185 to $380 for common issues like a dead gate motor, misaligned photo-eyes, or a keypad that stopped reading codes. Most repairs are done in one visit, and we always hand you a written price before any work starts. Whitney’s mix of horse properties, older ranches, and unincorporated lots means gates here take more abuse than most. Loose desert soil, irrigation overspray, and monsoon runoff all take a toll on posts, hinges, and underground wiring. We know what to look for out here because we work these streets every week. Need a real person now? Call (725) 529-9468.
Why Warden Gate Repair Las Vegas Is Whitney’s Preferred Electric Gate Repair Company
Whitney homeowners call us because we show up the way a gate company should. Before our tech arrives, you get their name and photo sent to your phone. When they ring the bell, their photo ID badge matches the person you were told to expect. That’s our Threshold Standard, and we don’t make exceptions for it.
We’ve worked electric gate repair jobs from the older lots along Boulder Highway to the horse-zoned parcels further east. The problems out here aren’t the ones you see in a HOA subdivision in Henderson. Whitney gates are heavier, older, and often custom-fabricated. Our techs know that a swing gate off a dirt driveway near the wash may need a post footing dug out and re-set before the operator can hold limits. That local knowledge is the difference between a repair that lasts and one you call about again in six months.
Warden Gate Repair is led by Cole Rafferty, and we’ve been doing gate and opener work since 2008 as part of the Threshold Group family. Every repair is backed in writing by our 365-Day Done Right Promise. If the work isn’t right, we come back and make it right, free. Our Electric Gate Repair team is factory-trained on the brands Whitney actually runs: LiftMaster, FAAC, BFT, Linear, Mighty Mule, and more.
Styles & brands we work with
Automatic Gate Repair in Whitney
Automatic Gate Repair in Whitney means getting a gate that opens and closes reliably on demand, not one that groans, reverses mid-travel, or leaves you stuck punching the remote. Around here, that work frequently starts with a gate that has never been serviced since it was installed, often a heavy steel or wrought-iron swing gate on pipe posts that have rusted through at the base where sprinklers hit them. We repair the gate, the operator, the wiring, and the posts as one system.
Posts, Sag, and Undersized Operators
A gate that sags or drags puts weight on the operator it was never designed to carry. In Whitney, we regularly see hinge posts rusted below grade from irrigation overspray. We dig out the footing, set a new post in concrete, and re-hang the gate so the operator isn’t fighting the load.
False Reversals and Sensor Faults
Dust and wind are facts of life east of the Strip. Photo-eyes get knocked out of alignment, loop detectors get buried under caliche, and the gate reverses before it closes. We clean, re-sight, and test entrapment sensors, then recalibrate limits so the gate runs full travel without refusing to latch.
Electric Gate Motor in Whitney
Electric Gate Motor work in Whitney means diagnosing whether the motor (the box that slides or swings your gate automatically) has failed, or whether it’s being fed bad information from a sensor, a control board, or a power supply. In our experience out here, the motor itself is often fine. What kills Whitney gate motors is what they’re attached to, heavy gates on failing posts, and what’s underneath them, underground operators that took in water after a flash flood near the Las Vegas Wash.
Underground Operator Water Intrusion
Whitney gets flash flooding, especially on the west side closer to the wash. Underground gate operators sit below grade in a vault, and when monsoon runoff finds a cracked lid or a failed seal, water gets in and shorts the control board. We open the vault, dry it out, replace the board, and reseal the lid so it survives next season.
Solar Battery and Heat Failure
Over 110°F for weeks at a time shortens solar battery life dramatically in Whitney. A gate that runs fine in March may refuse to open in July because the battery can’t hold charge under the heat load. We test batteries under load, not just at rest, and swap in replacements sized for Whitney summers.
Trusted Brands We Service in Whitney
We stock local parts for the brands Whitney actually runs. We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. We carry LiftMaster and FAAC boards and remotes on the truck for common Whitney callouts, and we can typically have BFT and Mighty Mule parts on-site the same week. Factory training matters when you’re reprogramming a LiftMaster operator to hold limits on a 16-foot steel swing gate. We’ve done that exact job on a Boulder Highway horse property.
See the difference
Before
After
Before
After
Before
AfterCommon Electric Gate Repair Problems We See in Whitney Homes
- Rusted hinge posts at ground level. Irrigation overspray soaks the base of pipe posts, they rust through, and the gate leans. The operator then strains against a load it can’t handle. We replace the post and re-set the footing in fresh concrete.
- Photo-eye misalignment from wind-blown dust. Whitney’s fine caliche dust coats sensor lenses and knocks mounts loose in seasonal winds. The gate reverses before it closes as a safety default. We realign, tighten, and lens-clean every eye as part of a repair.
- Underground operator water intrusion. Flash flooding from the Las Vegas Wash floods vaults on west-side properties. Control boards short and the gate goes dead. We dry the vault, replace the board, and reseal the lid.
- Missing or non-functional entrapment protection. Many older Whitney gates on unincorporated lots were installed before UL 325 requirements were enforced. A gate without working photo-eyes or an edge sensor is not safe to operate. We retrofit current entrapment protection before recalibrating the operator.
Pricing for Electric Gate Repair in Whitney, NV
Here’s what electric gate repair work typically costs in Whitney. A keypad or remote control repair runs $95 to $180. Photo-eye realignment and cleaning runs $120 to $200. A control board replacement on a swing or slide gate runs $280 to $520 depending on the board. A full gate motor replacement runs $450 to $1,100 installed, with underground operator motor swaps at the high end because of excavation and sealing. A post replacement with a new concrete footing runs $350 to $700. You’ll get a written price before any work begins, every time, and the price we quote is the price you pay. Call (725) 529-9468 for a free estimate.
We Also Serve Cities Near Whitney
Our Electric Gate Repair in Whitney crews also cover Las Vegas, Sunrise Manor, Centennial Hills, and Winchester. If your property sits on the edge of Whitney or just off Boulder Highway, we’ll still get a tech out to you, same scheduling, same Threshold Standard.
Serving Whitney, NV - Our Local Coverage Area
We’re based in the Whitney area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in Whitney
Your gate reverses because an entrapment sensor, usually a photo-eye or a loop detector, is telling the control board there’s an obstruction in the gate’s path. In Whitney, this is most often caused by misaligned photo-eyes from wind-blown dust, a loop detector buried under caliche, or rusted posts that have dropped the gate low enough to trip the sensor. We clean, realign, and test every sensor during a repair so the gate stops false-reversing. Call (725) 529-9468 and we’ll have a tech out to diagnose it.
Yes. In most cases we dig out the old footing, cut and set a new heavy-gauge post in concrete, and re-hang the existing gate. Whitney’s loose desert soil and irrigation overspray often undermine the original footing, but the gate itself is frequently fine. We match the hinge placement and re-level the gate so it swings true. A post replacement with new footing typically runs $350 to $700 in Whitney.
Yes. UL 325 compliant entrapment protection, usually photo-eyes plus an edge sensor or a reversing mechanism, is required on any automated gate. Many Whitney gates on unincorporated lots were installed before current standards, and we regularly find them missing sensors entirely. We retrofit current photo-eye and edge protection before we recalibrate the operator, because a gate that can’t sense a child, a pet, or a car is a gate we won’t leave running. Call (725) 529-9468 to have your system checked.
We test the battery under load, not just at rest, because Whitney’s 110°F summers kill solar batteries that look fine on a voltage meter. We then size the replacement battery for summer heat, clean the panel so caliche dust isn’t cutting output, and tighten all connections. If the opener’s location gets full afternoon sun on the control box, we may add a shade shield to keep the board from cooking. This is standard work for us in Whitney.
It’s common out here. Crushed gravel and caliche from long, unsurfaced Whitney driveways gets kicked up onto the track and into the rack teeth. Left alone, it chews up the pinion gear and causes the gate to bind. We clean the full track run, check the rack for wear, and may set the gate on a raised track or add a brush seal so the problem doesn’t come back in three months. Call (725) 529-9468 and we’ll take a look.
Written by Cole Rafferty, Owner at Warden Gate Repair Las Vegas, serving Whitney since 2008.
For electric gate repair in Whitney, call (725) 529-9468 for a free estimate and a written price before any work begins. A real person answers, 24 hours a day.