FAAC Electric Gate Repair Nationwide

FAAC Electric Gate Repair in Las Vegas: What to Know First

We fix FAAC electric gate systems across Las Vegas, usually same day or next morning depending on when you call. Most FAAC repairs run between $185 and $520, and you’ll always have a written price before we touch a single bolt. If your gate’s stuck, grinding, or refusing to open, call (725) 529-9468 and tell us what it’s doing wrong.

Call (725) 529-9468

This page is for homeowners with a FAAC opener who want to know what’s actually wrong, what it costs, and who’s showing up at the door. We’re an independent FAAC service provider, not a manufacturer affiliate, which means we tell you straight when a repair beats a replacement.

How FAAC Products Fail – and How We Fix Them

FAAC builds solid equipment. But Las Vegas heat, dust, and daily use create predictable failure points. Here’s what we see most on FAAC jobs in this valley:

• FAAC 400 Series swing operators with seized hinge bearings. The hydraulic piston keeps pushing, but the gate won’t move smoothly because the hinge bearings have dried out. We see this constantly in Summerlin and Henderson, where gates bake in direct sun for hours. We replace the bearings, lubricate the piston fittings, and the gate swings like new.
• FAAC 750 and 844 slide gate operators with bad limit switch contacts. The gate either overruns the opening or stops short because the limit switches are corroded. Fine desert dust gets inside the housing and coats the contacts. We clean or replace the switch assembly, re-set the limits, and verify the gate stops exactly where it should.
• FAAC control boards with blown motor relay. When the board clicks but the motor doesn’t fire, the relay has usually arced out after years of heavy cycling. On the 844C, we replace the relay or the board itself depending on board revision. We always check for underlying motor draw before assuming the board is at fault.
• FAAC photocell alignment failures. The safety sensors on both sides of the gate drift out of alignment, which makes the gate refuse to close. In Las Vegas, this gets worse when afternoon heat makes the metal posts expand. We align the sensors and tighten the mounts so they stay put.
• FAAC keypad membrane degradation from UV exposure. The rubberized buttons on FAAC keypads crack and lose responsiveness after three or four summers of direct sun. We replace the keypad with an OEM unit, or a quality aftermarket pad if the customer wants to spend less. The antenna wire routing is checked at the same time since poor receiver range often masks a bad keypad.

Our FAAC Electric Gate Repair Process

1. 1
   You call. A live person answers, not a voicemail. You describe the symptom, we give you a ballpark range over the phone, and we schedule a visit.
2. 2
   You get a name and a photo. Your technician is background-checked, identity-verified, and photo-badged under our Threshold Standard. You’ll know exactly who’s at the door and why they’re there.
3. 3
   We diagnose in front of you. We test the motor amperage, limit switches, sensors, and board. We show you what’s wrong, not just tell you. If it’s a $40 sensor and not a $500 board, you’ll know.
4. 4
   We source the right parts. On FAAC jobs, we prefer OEM parts for boards and motors, because aftermarket electronics often cause intermittent problems down the road. For keypads, remotes, and sensors, quality aftermarket units perform well and often cost 30-40% less.
5. 5
   We repair, test, and verify. The gate cycles ten times minimum. We check the closing force, auto-reverse, and sensor alignment before we call it done.
6. 6
   You get a written guarantee. Every repair is covered by our 365-Day Done Right Promise. If the repair fails within a year, we come back free and fix it right.

What FAAC Electric Gate Repair Costs in Las Vegas

Here’s what you can expect on FAAC systems in the Las Vegas market:

• Safety sensor replacement: $95-$180
• Limit switch replacement: $120-$210
• Keypad replacement: $150-$280
• Remote control programming/replacement: $65-$200
• Control board repair or replacement: $240-$520
• Full swing or slide motor replacement: $400-$900

The price moves based on your FAAC model, the age of the unit, and whether the failure is electrical, mechanical, or both. Older FAAC 400 Series hydraulic units that have been neglected for years can push costs higher, but we will never surprise you. The written price is given before any work starts, always. Call (725) 529-9468 for a free estimate.

Why Las Vegas Homeowners Call Warden Gate Repair Las Vegas for FAAC Work

A gate that won’t open is a nuisance. A gate that won’t close is a security problem. In either case, you want the person fixing it to know FAAC systems the way a mechanic knows a specific make of car. That’s why we exist. Cole Rafferty built Warden Gate Repair around one thing he couldn’t find when he needed a repair himself: a straight answer on what it costs before anyone picks up a wrench. Every tech who shows up is background-checked, photo-badged, and sent to you by name before arrival. That’s the Threshold Standard, and we enforce it on every visit. We also service LiftMaster, Mighty Mule, Ghost Controls, and DoorKing systems, so if your property has mixed equipment, one call covers it all. Tell me what it’s doing wrong, and I’ll tell you exactly what it costs to fix it.

FAQs