Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGhost Controls Keypad & Intercom Repair: The Las Vegas Owner’s Guide
Ghost Controls keypad and intercom repair in Las Vegas typically runs $145 to $310 installed, and we stock the most common replacement keypads and intercom modules on our trucks so most swaps happen same day. Most owners discover the failure the same way: the gate works fine from a remote or the push button inside, but the keypad outside has gone dead, started spitting out random codes, or the intercom audio sounds like a wind tunnel full of static. Here’s the good news: Ghost Controls keypads and intercoms are wired through the same control board, which means we can isolate whether it’s the keypad itself, the intercom module, or the wiring between them in one visit.
If you’re in Las Vegas and you’ve been typing your PIN three times before the gate opens, or you’re holding the handset like a hostage negotiator just to hear someone at the door, we can tell you exactly what’s wrong and exactly what it costs before any work starts. That’s how we run every visit, no exceptions.
Which Ghost Controls Models This Applies To
Ghost Controls uses a fairly consistent keypad and intercom architecture across their residential opener line, but there’s a compatibility gotcha you should know before you order parts yourself. Older Ghost Controls systems, specifically the AXDP and AXD series from the 2010s, use a wired keypad that connects via a dedicated screw terminal on the control board. Newer systems, including the TSS1 and TDS2 lines, moved to a different connector style and a slightly different keypad protocol, so a keypad that plugs into one doesn’t always talk to the other.
The quickest way to identify what you have: open the control board cover and look at the keypad connection point. If it’s a green screw terminal block, that’s the earlier generation. If it’s a white plastic snap-in connector, it’s the newer generation. We carry both OEM Ghost Controls keypads and quality aftermarket equivalents on our trucks, and we’ll match what’s actually correct for your board rather than selling you whatever happens to be in the truck. For intercoms, Ghost Controls offers a few different modules depending on whether you have an audio-only entry or a video-capable system, and the range between the gate and the house unit matters more in Las Vegas than most people expect.
One more thing worth knowing: Warden Gate Repair Las Vegas is an independent service provider, not affiliated with Ghost Controls. That’s actually useful for you, because it means we’ll give you an honest read on whether a repair, an OEM replacement, or an aftermarket equivalent is the smartest way to spend your money.
Styles & brands we work with





Signs Your Ghost Controls Keypad or Intercom Is Failing
- Keypad works sometimes, then stops. A keypad that’s intermittent is usually a failing tactile switch inside the keypad or a micro-fracture in the keypad cable that flexes every time the gate cycles. The switch is the single most common failure point we swap out in Las Vegas, because the summer heat and UV beat on the keypad surface for months straight.
- The gate beeps but doesn’t open when you enter your PIN. The keypad is sending signal, but the control board isn’t acting on it. That usually means a bad relay on the keypad output or a control board input that’s gone weak. Either way, it’s a diagnosis issue, not a guess.
- Intercom hums or buzzes at the gate, even when no one’s pushed the call button. That’s a failing electrolytic capacitor inside the intercom module at the gate. We see a lot of these in Las Vegas because the capacitors dry out faster in extreme heat, and once they go, the audio becomes a constant low-frequency drone.
- The keypad backlight stays on all night or renders the buttons unreadable in daylight. Ghost Controls keypads use a small backlight circuit that’s tied to the same board as the button matrix. If the backlight is misbehaving, the board inside the keypad is on borrowed time, and we usually recommend swapping the keypad rather than chasing individual components.
- You have to press the buttons harder and harder to get them to register. That means the membrane layer under the buttons is wearing out, or the contacts are oxidizing from moisture intrusion. It’s common in Las Vegas after a few years because the extreme temperature swings between day and night cause micro-condensation inside the keypad housing.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For Ghost Controls keypad replacement in Las Vegas, you’re looking at $145 to $220 installed, including the part, labor, and reprogramming. This is a repair-and-restore job, not an addition to a system that never had a keypad. The price assumes a standard residential gate, ready access to the keypad wiring spot, and no preexisting damage to the control board inputs. Warden Gate Repair Las Vegas will always quote a written price before any work starts, and if the job is bigger once we get in there, we’ll stop and call it out before doing anything extra. No surprise line items, no “discovered fees.”
Intercom modules run a bit more: $185 to $310 installed, depending on whether we’re replacing an audio module at the gate, the handset in the house, or both. We stock aftermarket and OEM Ghost Controls intercom modules, and we’ll tell you the difference in durability honestly. Anything we install is covered by the 365-Day Done Right Promise, which means if the repair isn’t right, we come back and make it right, free of charge.
We do not charge you to drive across town. Our service call is included in the installed repair price, so the number we quote is the number you pay.
DIY or Call Us?
There are a handful of things you can check yourself before calling us. First, confirm the keypad isn’t just a dead 9-volt battery if you have a wireless Ghost Controls keypad. Some models use a battery that runs down without warning. Second, eyeball the wiring connection for a loose terminal or a rodent chewed through the cable. Desert pack rats are brutally efficient at that kind of destruction, especially in neighborhoods near the edges of Summerlin and Henderson. Third, check that your gate opener itself is getting power, because a dead opener can make the keypad look like the culprit.
But opening a control board and probing terminals is not a casual Saturday project. Ghost Controls boards carry low-voltage, but a short across the wrong two terminals can smoke the board or the transformer, and now you’re out $400 instead of $145. If the keypad or intercom is going to be replaced, let a real gate tech do it. Warden Gate Repair Las Vegas is built on this: we’re happy to talk you through it on the phone, and if it’s past an easy check, call us and we’ll send someone out.
Tell me what it’s doing wrong, and I’ll tell you exactly what it costs to fix it. That’s how we operate, and it’s how every Warden call starts.
FAQs
In Las Vegas, a Ghost Controls keypad typically lasts 5 to 8 years before the buttons or membrane wear out. The heat, UV, and hard water from sprinkler overspray all take their toll on the keypad face faster here than in coastal climates, and we see plenty of units fail at the 5-year mark when they’re mounted on a west-facing wall. Call (725) 529-9468 for an exact quote, and we’ll help you figure out if a repair or replacement is the better money.
It depends on what’s failed. A dead button or a cracked membrane inside the keypad can sometimes be repaired by replacing the internal switch panel, but most Ghost Controls owners choose to replace the keypad because it’s faster and the cost difference is small. For intercoms, a failed capacitor or shorted diode can often be repaired on the bench, but if the audio chip has failed, replacement is the only real fix.
Most keypad swaps take about 45 minutes from start to finish, including reprogramming your existing PIN and verifying the gate opens and closes correctly. A full intercom module replacement, especially if we’re doing both the gate module and the in-house handset, usually runs 60 to 90 minutes. Call (725) 529-9468 and we’ll give you a written price and a reliable arrival window.
Yes, Warden Gate Repair Las Vegas keeps Ghost Controls keypads, intercom modules, and control board components on the truck. We also carry aftermarket equivalent parts that fit Ghost Controls systems, and we rarely have to order anything for a keypad or intercom job. In the rare case we need a specialized part, we’ll tell you upfront and get it on order the same day.
Written by Cole Rafferty, Owner, Warden Gate Repair Las Vegas, serving Las Vegas and nearby areas.